Xenium Pro v3.1 Modchip

Nemesis Xenium Pro v3.1 programmed with PrometheOS

Features Include:

– Install up to 4 different banks at the same time.
– Quick-Solder and Pin Header Install Methods
– Dual SPI port for unlimited future add-ons.
– Compatible with all versions of original Xbox consoles.
– Full RGB Status/Bank LED
– Hardware protected Emergency Recovery System.
– Inbuilt Flash system via OS or Web Browser.
– Minimal stress is applied to the D0 line by only pulsing D0 at reset time, all other times the D0 is left free.

Installation suggestion: A 14 pin header is included so that you may insert the D0 wires to pass under the board and solder to the Easy D0 points on the LPC rebuild. Refer to the guide image in the listing.

What’s Included:
1x XeniumICE – version 3.1
1x 14pin Header (be sure to remove pin 4 before installation)

Whilst stocks are available:
1x 2pin Cables (these are for grounding your D0 point so that the Xbox knows to boot from the chip) Direct solder to PCB if not included.
1.6 variation has 1x XeniumLPC – v1.6 Rebuild with Easy D0 pads